Rockwell Automation 2094-SEPM-B24-S Kinetix 6000M IDM Power Interface Module - Manual (Page 6)

6 Kinetix 6000M Integrated Drive-Motor Power Interface Module
Publication 2094-IN016A-EN-P - February 2012
Mount the IPIM Module
All modules mount to the power rail by using the same technique.
1. Remove the protective covers from the power rail connectors.
2. Determine the next available slot and module for mounting.
3. Inspect the module connector pins and power rail connectors and remove any foreign
objects.
4. Hang the module mounting bracket from the slot on the power rail.
IMPORTANT The IAM must be positioned in the leftmost slot of the power rail. Position your other modules
to the right of the IAM module.
Mount modules according to power utilization (highest to lowest) from left to right starting
with the highest power utilization. If power utilization is unknown, position modules (highest
to lowest) from left to right based on continuous power rating (kW). Refer to
page 5 .
The shunt module must be installed to the right of the last module. Install only slot-filler
modules to the right of the shunt module.
Do not mount the shunt module on power rails with a follower IAM module. Common bus
follower IAM modules disable the internal, rail mounted, and external shunt modules.
SHOCK HAZARD: To avoid personal injury due to electrical shock, place a 2094-PRF slot-filler
module in all empty slots on the power rail. Any power rail connector without a module installed
will disable the drive system, however, control power will still be present.
ATTENTION: To avoid damage to the pins located on the back of the module and to
make sure that module pins mate properly with the power rail, hang modules as shown.
Slots for Additional Modules
Power Rail Slot
Mounting Bracket
Power Rail