Rockwell Automation 8520-OM Offline Development System User Manual - Manual (Page 50)

5--8 Using ODS for Project Management
Publication 8520--UM051A--EN--P -- October 2000
Offline Development Manual (ODS) Software User Manual
The Change Info option lets you change the following information
for the active project:
• communication selection • date created
• developer’s name • comments (2 lines)
If you want to change the control type or the firmware revision, you
must create a new project. Use F2-Copy Project to copy the original
project.
1. Press [ F2 ] and pull down the F2-Project menu.
2. Select the Change Info option.
ODS displays the communication menu:
3. To change your selection:
To: Select:
the serial port for standard RS232 communication (C)
the port for the Data Highway Plus network 1 (D)
the port for Ethernet/OCI communication 1 (E)
communicate with 9/PC, using your PC (P)
1 The configuration menu flow for the Data Highway Plus and Ethernet are in
Chapter 7.
Important: You can configure ODS to the DH+ network if the Data
Highway selection is not ghosted.
Changing Project
Information