Rockwell Automation 8520-OM Offline Development System User Manual - Manual (Page 17)

2--3 Installing ODS
Publication 8520--UM051A--EN--P --July 2000
Offline Development Manual (ODS) Software User Manual
If you see the message: then:
A directory called \IMC already exists (on
drive c:). If you are certain that this directory
was created by an earlier version of
Allen-Bradley’s ODS, then proceed with the
installation. Otherwise, press CTRL-C now
and verify that this directory may be
overwritten.
Press any key to continue... The hard disk contains the
directory \IMC.
IMC files already exist in the
directory. Follow the instruction
on the screen. (Most ODS files
are installed in this directory.)
Important: Selecting Press any key to continue... will not
affect any existing AMP, PAL, or logic files.
5. To continue or abort the installation, follow the flowchart below:
Continue
Enter: [Cntrl-C]
or
Abort
Installation
Msg:
Terminate
Batch Job
Y/N
Press any key
Go to
Step 6
Enter: [N]
Enter: [Y]
Yes
Abort
Continue
Computer
returns to
DOS
No
Important: Pay particular attention to the following when
you install ODS software:
•
If you press any key to continue, files stored in the \IMC
directory are overwritten.
•
If you are not sure this is acceptable, press [CTRL-C] to abort
installation.
•
Check files stored in the \IMC directory.
•
Copy any files that need to be saved to another directory; delete
the files from the \IMC directory.
•
Start installation again.