Rockwell Automation 2706-DXX Dataliner Message Display DL5 Series - Manual (Page 118)

DL5 Edit Commands
Keys Pressed Command Function
[CTRL] [A] Allows access to previously entered message attributes
so they can be reviewed or changed.
[CTRL] [C] Centers a message on the display.
[CTRL] [D] Deletes a single message block.
[CTRL] [E] Erases an entire message.
[CTRL] [F] Shows the number of message blocks that are not
programmed (free).
[CTRL] [H] Moves the cursor one character position to the left.
[CTRL] [I] Inserts a message block between two previously
entered message blocks.
[CTRL] [J] Creates a new message block after previously entered
message blocks or moves the cursor one message block
towards the end of a message.
[CTRL] [K] Moves the cursor one message block towards the
beginning of a message.
[CTRL] [L] Moves the cursor one position to the right.
[CTRL] [Q] Exits the edit mode with save.
[CTRL] [R] Runs a message in the edit mode.
[CTRL] [V] Imbeds a single digit variable in a message. Displays
the data without leading zeros.
[CTRL] [X] Imbeds a single digit variable in a message with leading
zeros.