Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 75)

Rockwell Automation Publication 1783-UM005A-EN-P - September 2013 75
Configure the Stratix 5900 Services Router by Using CISCO IOS Command-line Interface (CLI) Chapter 4
Display Interface States
To view information about a particular interface, use the show interface
command. The show interface command provides the following list of important
information:
• Interface State, for example, UP, DOWN, and LOOPED
• Protocol addresses
• Bandwidth
• Reliability and Load
• Encapsulation type
• Packet Rates
• Error Rates
• Signaling Status, for example, DCD, DSR, DTR, RTS, and CTS
The following is an example of a ‘show interface serial0’ output:
Router#show interface serial 0
Serial0 is up, line protocol is down
Hardware is QUICC Serial
Internet address is 10.1.1.2/24
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely
255/255, load 1/255
Encapsulation FRAME-RELAY, loopback not set,
keepalive set (10 sec)
LMI enq sent 207603, LMI stat recvd 113715, LMI upd
recvd 0, DTE LMI
down
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 1023 LMI type is CISCO frame relay DTE
Broadcast queue 0/64, broadcasts sent/dropped 0/0,
interface broadcasts
62856
Last input 1w, output 00:00:08, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output
drops: 0
Queueing strategy: weighted fair
Output queue: 0/64/0 (size/threshold/drops)
Conversations 0/1 (active/max active)
Reserved Conversations 0/0 (allocated/max
allocated)
5 minute input rate 1000 bits/sec, 1 packets/sec