Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 22)

22 Rockwell Automation Publication 1783-UM005A-EN-P - September 2013
Chapter 2 Install Stratix 5900 Services Router
Terminal Emulator Application Settings
Use these settings for the terminal emulator connection.
• 9600 baud
• 8 data bits, no parity
• 1 stop bit
• No flow control
When the terminal emulator establishes communication, the router prompt is
displayed.
For more information on terminal emulation settings, see Applying Correct
Terminal Emulator Settings for Console Connections on the Cisco website.
Connecting a Modem to the
Console Port To connect a modem to the router, follow these steps:
1. Connect the RJ-45 end of the adapter cable to the Console port on the
router.
2. Connect the DB-9 end of the console cable to the DB-9 end of the modem
adapter.
3. Connect the DB-25 end of the modem adapter to the modem.
1 RJ-45 connector to the Console Aux port on the router
2 DB-9 connector
3 Console cable
TIP Make sure that your modem and the router console port are configured for the
same transmission speed (up to 115200 b/s is supported) and support mode
control with data carrier detect (DCD) and data terminal ready (DTR).
32446-M
RESET
SERIAL CON / AUX
GE WAN 0
FE 1 S L FE 0 S L
FE 3 S L FE 2 S L S L
SYS
ACT LAN
1
3
2