Rockwell Automation 1783-SR Stratix 5900 Services Router User Manual - Manual (Page 61)

Rockwell Automation Publication 1783-UM005A-EN-P - September 2013 61
Configure the Stratix 5900 Services Router by Using CISCO IOS Command-line Interface (CLI) Chapter 4
2. Type disable at the Router# prompt to switch back to user EXEC level.
Typing a question mark (?) at the privileged EXEC level reveals many
more command options than those available at the user EXEC level.
Router> enable
Password: [enable password]
Router# disable
Router>
Once an EXEC session is established, commands within Cisco IOS are
hierarchically structured. To successfully configure the router, it is important to
understand this hierarchy. This graphic illustrates a simple high-level schematic
diagram of some IOS commands.
Command options and applications vary depending on position within this
hierarchy. Configuration command options are not available until you have
navigated to the configuration branch of the IOS CLI structure.
TIP For security reasons, the router does not echo the password that is
entered. If configuring a router via telnet, the password is sent in clear
text. Telnet does not offer a method to secure packets.