Rockwell Automation 1792D-16BVT0CD ArmorBlock MaXum 16 Input Module with Complete Diagnostics - Manual (Page 9)

ArmorBlock MaXum 16 Input Module with Complete Diagnostics 9
Publication 1792D-IN053A-EN-P - August 2002
Input connectors for this module are shown below.
DeviceNet Cable
DeviceNet cables are described in the installation publications for the
cable base of your choice. Refer to the following publications:
ATTENTION
!
•
Make sure all connectors and caps are securely tightened
to properly seal the connections against leaks and
maintain IP67 requirements.
•
For maximum noise immunity, input and output cable
return wires must be properly terminated. When inputs
and outputs are connected in loopback, return wires
should be connected together.
•
I/O cable length should be less than 30 meters.
WARNING
!
If you connect or disconnect the DeviceNet cable with
power applied to this module or any device on the network,
an electrical arc can occur. This could cause an explosion
in hazardous location installations.
Be sure that power is removed or the area is nonhazardous
before proceeding.
30722-M
Input 0
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Input 15
Input 14
Input 13
Input 12
Input 11
Input 10
Input 9
Input 8
Connector A
Connector B
Connector C
Connector D
Connector H
Connector G
Connector F
Connector E