Rockwell Automation 1792D-16BVT0CD ArmorBlock MaXum 16 Input Module with Complete Diagnostics - Manual (Page 5)

ArmorBlock MaXum 16 Input Module with Complete Diagnostics 5
Publication 1792D-IN053A-EN-P - August 2002
Install Your ArmorBlock MaXum I/O Module
To install the module:
•
Set the node address
•
Mount the module to the cable base
•
Connect the cord sets
•
Communicate with the module
Set the Node Address
Valid node addresses are 00 to 63.
Set the node address using the rotary switches, DeviceNetManager

,
RSNetWorx for DeviceNet

, or other software configuration tool.
Setting the switches between 64 to 99 lets the software have address
control.
Each module is shipped set for node address 63. The switches are
located on the underside of the module. The two switches are:
•
MSD (most significant digit)
•
LSD (least significant digit)
To reset the node address, use a small blade screwdriver to rotate the
switches. Line up the small black dot on the switch with the number
setting you wish to use.
ATTENTION
!
Preventing Electrostatic Discharge
This equipment is sensitive to electrostatic discharge, which
can cause internal damage and affect normal operation.
Follow these guidelines when you handle this equipment:
•
Touch a grounded object to discharge potential static.
•
Wear an approved grounding wriststrap.
•
Do not touch connectors or pins on component boards.
•
Do not touch circuit components inside the equipment.
•
If available, use a static-safe workstation.
•
When not in use, store the equipment in appropriate
static-safe packaging.