Wire the module – Rockwell Automation 1734D-1B8XOW8S 8 Input/8 Relay Output Module Installation Instructions User Manual
Page 9
POINTBlock dc 8 Input/8 Relay Output Module 9
Publication
1734-IN021C-EN-P - September 2006
Wire the Module
Refer to the figures that show how to wire the module.
WARNING
When you connect or disconnect the Removable Terminal Block
(RTB) with field-side power applied, an electrical arc can occur.
This could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before
proceeding.
WARNING
If you connect or disconnect the communications cable with power
applied to this module or any device on the network, an electrical
arc can occur. This could cause an explosion in hazardous location
installations.
ATTENTION
To comply with the CE low voltage directive (LVD), this equipment
must be powered from a source compliant with the following: safety
extra-low voltage (SELV) or protected extra-low voltage (PELV).
WARNING
If you connect or disconnect wiring while the field-side power is on,
an electrical arc can occur. This could cause an explosion in hazardous
location installations. Be sure that power is removed or the area is
nonhazardous before proceeding.