Rockwell Automation 1756-DHRIO_DHRIOXT ControlLogix Data Highway Plus-Remote I/O Communication Interface Module - Manual (Page 23)

Rockwell Automation Publication 1756-UM514C-EN-P - June 2014 23
Using the Data Highway Plus Network Chapter 2
Programming Terminal Port
The programming terminal connector is the same physical link as Channel A.
Connect Devices to the DH+
Network The following table lists the devices you can connect to a DH+ link.
41279
Programming Terminal Connector
Channel A
IMPORTANT When configuring the module switches, remember the programming
terminal connector can be used only if Channel A is set for DH+.
To: You can use: Cat. No.: Required
Cables
(1) :
Connect PLC-3 family processors to DH+ Scanner Communication Adapter Module 1775-S5 1770-CD or
Belden 89463
1775-SR5
Connect PLC-5 family processors to DH+ Classic and Enhanced PLC-5 processors using on-board DH+ ports 1785-Series 1770-CD or
Belden 89463
ControlNet and EtherNet PLC-5 processors using on-board DH+ ports
Connect SLCs to DH+ SLC 5/04 Controller 1747-Series 1770-CD or
Belden 89463
Connect PI systems to DH+ Resource Manager Module 5130-RM1 1770-CD or
Belden 89463
Resource Manager Module 5130-RM2
Data Highway/Data Highway Plus
Communication Interface Module 5130-KA
Perform data transmission, management, and local network
diagnostics over DH+ network KTX Communication Interface Card 1784-KTX 1770-CD or
Belden 89463
Perform data transmission, management, and local network
diagnostics over DH+ network KTXD Communication Interface Card 1784-KTXD 1770-CD or
Belden 89463
Add memory, storage, and I/O capabilities to computers through
DH+ PCMK Communication Card 1784-PCMK PCM6/B cable
assembly
Connect other SLC controllers to DH+ SLC 5/04 1747-Series 1770-CD or
Belden 89463
Connect AutoMax to DH+ AutoMax DH+ Interface 57C-442 1770-CD or
Belden 89463
(1) Use 1770-CD for 1756-DHRIO modules and Belden 89463 for 1756-DHRIOXT modules.