Rockwell Automation 1771-OFE Analog Output Module Installation Instructions - Manual (Page 7)

Analog Output Module 7
Publication 1771-IN044C-EN-P - October 2002
To set the last state configuration jumpers,
proceed as follows.
!
ATTENTION
Do not insert modules
into or remove modules
from the I/O chassis
while system power is
ON. Failure to observe
this rule could result in
damage to module
circuitry and unexpected
machine operation.
Output
Range
Selection
Minimum
Value
Middle
Value
Maximum
Value
4Ć20mA 4mA 12mA 20mA
0Ć50mA 0mA 25mA 50mA
1Ć5V 1V 3V 5V
0Ć10V 0V 5V 10V
+10V Ć10V 0V +10V
These output conditions are active only if
the following conditions exist:
• the module faults
•
the processor is in the PROGRAM or
TEST mode
•
rack switch 1 is in the reset position
Locate the last state configuration jumpers. You do not need to
remove the module cover.
11
Last State Output Level
Configuration Jumpers
MIN
MID
MAX
Front of Circuit Board
HOLD LAST STATE
Top View
13
Carefully reposition the jumper to reflect the desired values in
the table to the left.
12
Carefully pull up on the jumper to remove it from the pins.