Rockwell Automation 1756-ENBT ControlLogix EtherNet/IP Bridge Module Installation Instructions - Manual (Page 17)

ControlLogix EtherNet/IP Bridge Module 17
Publication 1756-IN019C-EN-P - November 2004
Link Status Indicator
The Link Status LED provides the following information:
OK Status Indicator
The OK Status LED provides the following module information:
Where to Find Information on Configuring the Module
To configure your module, refer to the configuration chapter of your
EtherNet/IP Modules User Manual, publication number ENET-UM001,
available online at www.rockwellautomation.com/literature.
State Status Description
Off No data transmission Module is not ready to communicate.
Green Ready Module is ready to communicate.
Flashing Green Data transmission in
progress Module is communicating over the
network.
State Status Description
Off No Power Module does not have 24V DC power.
Verify there is chassis power and the
module is completely inserted into
chassis and backplane.
Flashing Green Standby Module is not configured.
Green Operational Module is operating correctly.
Flashing Red Minor Fault A recoverable fault has been detected.
This could be caused by an error in the
configuration.
Red Major Fault An unrecoverable fault has been
detected. Recycle power to the module.
If this does not clear the fault, replace
the module.
Flashing Red and Green Self Test Module performing power-up self-test.