Rockwell Automation 1747-PTxx Getting Started Guide for HHT - Manual (Page 26)

A–B
3 Chapter
Getting Started Guide
for HHT
3–1
Creating a Program
In this chapter you create a program. The tasks you will perform:
•
For modular controllers: Make a record of the processor module catalog
number, the rack catalog number(s), the I/O module catalog numbers, and
the slot locations of I/O modules.
For fixed controllers: Make a record of the controller catalog number
(and I/O module catalog numbers and slot locations if you are using the
1746–A2 expansion rack).
•
Use the HHT to create a program.
•
Clear the HHT memory.
•
Name the program “1000.”
•
Enter the controller configuration.
•
Enter a 1–rung ladder program.
•
Save the program.
To make the best use of this guide, you should have access to an SLC 500
Demonstration Unit, which includes completely wired external inputs and
outputs. For the exercises in this guide, we assume that you are using a
Demo unit using a modular controller with the components listed on page
3–4.
Configuration of SLC 500
Controllers