Rockwell Automation 1783-EMS08T Stratix 6000 Ethernet Managed Switches Installation Instructions - Manual (Page 12)

12 Stratix 6000 Ethernet Managed Switches
Rockwell Automation Publication 1783-IN004B-EN-P - June 2014
Follow these steps to wire the switch.
1. Be sure power to the power supply is turned off.
2. Be sure you have the proper gauge of wire for your power supply.
3. Strip approximately 0.9 mm (0.35 in.) from each end of the wire.
4. Using a Phillips screwdriver, loosen the screw terminals on the terminal
strip at the bottom of the switch.
5. Connect DC+ (24V DC nominal) from the power supply to the DC+
terminal and tighten the screw.
6. Connect DC- (0V DC) from the power supply to the DC- terminal and
tighten the screw.
7. Connect functional earth ground to the ground terminal and tighten
the screw.
8. Refer to the grounding considerations on
page 15 .
9. Tug gently on the wires to ensure the connections are secure.
Connect the Copper Ethernet Ports
Follow these steps to connect the copper Ethernet ports on the switch.
1. Locate the copper Ethernet RJ-45 ports on the switch.
2. Connect one end of an Ethernet cable to one of the copper ports on the
switch.
3. Connect the other end of the Ethernet cable to a device in your Ethernet
network.