Rockwell Automation 1732E-OF4M12R ArmorBlock Dual-Port EtherNet/IP 4-Point Analog Input and Output - Manual (Page 6)

6 1732E ArmorBlock Dual-Port EtherNet/IP 4-Point Analog Input and Output Modules
Publication 1732E-IN006C-EN-E - June 2013
Optional Accessory
The following table identifies optional accessory that you can use with the modules that
have to be ordered separately.
Catalog Number Explanation
Refer to the table for a description of the module catalog numbers.
Install the Module
To install the module:
• Set the network address
• Mount the module
• Connect the Functional Ground and Module power/Auxiliary power cables
• Connect the I/O and Network cables to the module
Set the Network Address
The I/O block ships with the rotary switches set to 999 and DHCP enabled.
To change the network address, you can do one of the following:
• adjust the switches on the front of the module.
• use a Dynamic Host Configuration Protocol (DHCP) server, such as
Rockwell Automation BootP/DHCP.
Option Catalog Number
Snap-in individual marker card (1)
(1) Provides labelling for the terminal blocks to allow for easy identification and description.
1492-MD6X9
Catalog Number Description Network
Connector Power
Connector
1732E-IF4M12R 24V DC power, 4-Point Analog Input,
Dual-Port EtherNet/IP Module Dual D-code M12 Dual 4-pin micro
1732E-OF4M12R 24V DC power, 4-Point Analog
Output, Dual-Port EtherNet/IP
Module