Rockwell Automation 1732E-OF4M12R ArmorBlock Dual-Port EtherNet/IP 4-Point Analog Input and Output - Manual (Page 19)

1732E ArmorBlock Dual-Port EtherNet/IP 4-Point Analog Input and Output Modules 19
Publication 1732E-IN006C-EN-E - June 2013
Specifications
I/O status Off The input or output channel is inactive, can be calibrated.
Flashing Green Channel is calibrating.
Green 1732E-IF4M12R – Normal operation, inputs being scanned.
1732E-OF4M12R – The output is active and under control.
Flashing Red 1732E-IF4M12R – Fault. Channel is at end of range.
1732E-OF4M12R – Output fault. The output is open (current
mode only), or a low/high clamp alarm is present.
Red 1732E-OF4M12R – Auxiliary power disconnected or off.
IMPORTANT The Module Status LED indicator will flash red and green for a maximum
30 s while the module completes its POST (Power-On Self Test).
General Specifications
Attributes Value
Voltage, power, max 30V DC
Voltage, power, min 12V DC
Module power 12…30V DC @ 300 mA
Power consumption 3 W @ 24V DC, typical
3.5 W, max (module unloaded)
Isolation voltage 50V (continuous), Basic Insulation Type
Type tested @ 707V DC for 60 s
Communication rate EtherNet/IP
10/100 Mbps
Full or half-duplex
100 meter per segment
Status indicators Module status – red/green
Network status – red/green
Link status – green/yellow
Auxiliary power status – green
I/O LED – red/green
Indicator Status for Modules
Indicator Status Description