Rockwell Automation 1784-KTCX15 INSTL INSTR CONTROLNET COMM. - Manual (Page 4)

4 ControlNet Communication Interface Card
Publication 1784-5.33 – September 1997
ATTENTION: This digital apparatus does not exceed the Class A
limits for radio noise emissions from digital apparatus set out in the
Radio Interference Regulations of the Canadian Department of
Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de la class A
prescrites dans le Règlement sur le brouillage radioélectrique édicté par
le ministère des Communications du Canada.
Handling the Card
ATTENTION: The card uses CMOS technology, which is highly
sensitive to electrostatic discharge (ESD). ESD may be present
whenever you are handling the card. Handling a card
without any ESD protection can cause internal circuit
damage that may not be apparent during installation
or initial use. A grounding wrist strap has been
shipped with the card and is to be worn during the
installation procedure. Instructions for use of the
strap are found on the back of its package.
Take these precautions to guard against ESD damage:
•
Before handling the card, be sure to wear the provided static strap and touch
a grounded object to discharge any built-up static charge.
•
Avoid touching the backplane connector or interface connector pins located
on the card.
•
If the card is not in use, store it in the anti-static clamshell that the card was
shipped in.
Important: Remember, a computer with ac power disconnected is not a
grounded object.
You are now ready to configure your card.
wrist-strap
grounding
device