Rockwell Automation 1336 3-20HP FRN 1.01-3.01 - Manual (Page 92)

10
Chapter
10-1
Fault Codes
Up to 37 fault codes may be displayed for the 1336. In each instance, a
Fault may be reset by cycling power to the drive, or if Parameter 39 is set
to 1, by pressing the Stop pushbutton. Resetting a Fault will not correct the
problem. Corrective action must be taken prior to resetting the fault.
2ĆPosition Mode Display Area
Freq P R
The two character P
R
display is not used as part of the fault code display.
However, it may be used to indicate the loss of enable.
3ĆPosition Fault Code Display Area
Freq P R
The three character Freq display is used to indicate the fault code acronym.
The fault acronym will be displayed until a drive reset is initiated.
Special Display - Enable Fault
Freq P R
The enable interlock is open. The enable interlock is:
Jumper 7-8 of J9 on the Main Control Board if interface option L1, L2, L3
is not installed.
Terminal 30 of TB3 if interface option L1, L2, L3 is installed.
Special Test - Input Reset
Freq P R
This is not a fault but a code that is displayed each time the drive is
powered up or when a fault is cleared. It indicates that drive logic is being
reset to initial conditions.