Environmental compliance, Physical dimensions and weight – Rockwell Automation 1606-XL240-UPSE Power Supply Reference Manual User Manual
Page 17

All parameters are specified at an input voltage of 24V, 10A output load, 25°C ambient and after a 5 minutes run-in time unless noted otherwise.
It is assumed that the input power source can deliver a sufficient output current.
Rockwell Automation Publication 1606-RM013A-EN-P — March 2014
17
Bulletin 1606 Switched Mode Power Supplies
23. Environmental Compliance
The unit does not release any silicone and is suitable for use in paint shops.
Electrolytic capacitors included in this unit do not use electrolytes such as Quaternary Ammonium Salt Systems.
Plastic housings and other molded plastic materials are free of halogens, wires and cables are not PVC insulated.
The materials used in our production process do not include the following toxic chemicals:
Polychlorinated Biphenyl (PCB), Pentachlorophenol (PCP), Polychlorinated naphthalene (PCN), Polybrominated
Biphenyl (PBB), Polybrominated Biphenyl Oxide (PBO), Polybrominated Diphenyl Ether (PBDE), Polychlorinated
Diphenyl Ether (PCDE), Polybrominated Diphenyl Oxide (PBDO), Cadmium, Asbestos, Mercury, Silica
24. Physical Dimensions and Weight
Width
49mm / 1.93’’
Height
124mm / 4.88’’
Plus height of signal connector plug
Depth
117mm / 4.61’’
Plus depth of DIN rail
Weight
545g
/
1.2lb
DIN Rail
Use 35mm DIN rails according to EN 60715 or EN 50022 with a height of 7.5 or 15mm.
The DIN rail height must be added to the depth (117mm) to calculate the total required installation
depth.
Fig. 24-1 Side view
Fig. 24-2 Front view