Rockwell Automation 21G PowerFlex 755 Transition Section and Splicing Kit User Manual
Installation instructions, Introduction, Compatibility
Installation Instructions
PowerFlex 755 Transition Section and Splicing Kit for Floor-
mount Drives and CENTERLINE 2100 Motor Control Centers
Introduction
This document explains the recommended procedures that you should use when
joining and splicing a PowerFlex® 755 Floor-mount drive, Frames 8…10, with a
CENTERLINE® 2100 Motor Control Center (MCC).
Before you begin, familiarize yourself with the installation requirements and
recommendations for both the PowerFlex 755 drive and the CENTERLINE
2100 MCC.
Compatibility
The transition section and splicing kit is designed to join together a PowerFlex
755 floor-mount drive and a CENTERLINE 2100 MCC column with or
without 1.5 inch mounting channels.
Diagrams in this publication show the mounting channels installed. Mounting
channels will not be used in all installations.
Topic
Page
Introduction, Compatibility
1
Additional Resources
2
What the Kits Contain
2
Remove Power from All Equipment
3
Approximate Dimensions
4
Preparing the Transition Section
5
Joining Drive, Transition Section, and MCC
6
Left-side Kit Assembly
7
Right-side Kit Assembly
14
Specifications
25
Mounting Channels