Commonly used tools, Installation and service tools, N223 – Rockwell Automation 20B Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 User Manual
Page 2: Series: b

2
Rockwell Automation Publication 20B-IN028B-EN-P - August 2014
Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10
Commonly Used Tools
Installation and Service Tools
The following list covers the tools needed for replacing the balancing resistor on a
PowerFlex® 700 drive.
• Ohm meter
• T20 Torx driver
• Torque wrench with 2.3…23.7 N•m (20…210 lb•in) range
• 10 mm socket wrench (must fit torque wrench)
• 17 mm socket wrench (must fit torque wrench)
• 17 mm combination wrench
• 3/8 in. socket wrench
• 5/16 in. combination wrench
• Wire crimper for non-insulated terminals (18 AWG wire)
Identifying Information on
the PowerFlex 700 Drive
Nameplate
The nameplate (found on the front of the PowerFlex 700 drive, below the
Plexiglas shield) provides information that lets you determine if you need to
replace the balancing resistor.
IMPORTANT
Care must be taken to be sure that tools and/or hardware components do not
fall into open drive assemblies. Do not energize the drive unless all loose tools
and/or hardware components have been removed from the drive assemblies
and enclosure.
Cat No. 20B D xxx x x xxxxxxx
Made in the USA (TAC 1J)
Rockwell Automation, Mequon WI 53092-4400
UL TYPE 1/IP20
Mfd. in 2007 on Aug 1
Frame:
5
Serial Number: xxxxxxx
Series: B
I/O: 24VAC/DC (Standard)
Original Firmware V. x.xxx
Listed
Ind. Cont
Eq. 966X
U
c
US
L
Normal Duty Power
Heavy Duty Power
AC Voltage Range
Amps
Input: 3 Phase, 47-63Hz
Output: 3 Phase, 0-400 Hz
AC Voltage Range
Base Hz (default)
Continuous Amps
1 Min Overload Amps
3 Sec Overload Amps
xxx kW
xxx kW
342-440
xxx
0-400
50 Hz
xxx
xxx
xxx
xxx kW
xxx kW
432-528
xxx
400V
480V
0-460
60 Hz
xxx
xxx
xxx
N223
Voltage Code
Current Rating
Frame Size
Catalog Number
- SK-G1-CBRB1-F910 Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 SK-G1-RB1-F910 Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 SK-G1-CBRB1-F8 Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 SK-G1-RB1-F8 Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10