Rockwell Automation 20B Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 - Manual (Page 14)

14 Rockwell Automation Publication 20B-IN028B-EN-P - August 2014
Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10
9. Verify that the yellow resistor wire is long enough to connect to the left
terminal (R2) on the top of the resistor assembly. To do so, route the wire
through the bottom and out of the top of the holes in the insulator
material on the resistor assembly (as shown in the following images).
Note: If the yellow resistor wire is not long enough to reach the top
terminal (R2) when routed through the assembly, it is acceptable to leave
the wire outside of the assembly to make the connection.