Rockwell Automation 20B Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 User Manual
Page 12
12
Rockwell Automation Publication 20B-IN028B-EN-P - August 2014
Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10
b. Remove the two bolts from the bottom of the bus bar (as shown in the
following image).
c. While holding the bus bar, remove the nuts that secure the bus bar to
the chassis and remove the bus bar.
IMPORTANT
The set screws can come out when a nut is removed.
c
This manual is related to the following products:
- SK-G1-CBRB1-F910 Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 SK-G1-RB1-F910 Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 SK-G1-CBRB1-F8 Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10 SK-G1-RB1-F8 Replacing a Balancing Resistor on a PowerFlex 700 Drive, Frames 8, 9, and 10