Rockwell Automation 20P PowerFlex DC Drive - Frame A Pulse Transformer Circuit Board - Manual (Page 15)

PowerFlex® DC Drive - Frame A Pulse Transformer Circuit Board 15
2. Connect the leads of a multimeter to pins 13 and 14 of connector XR on
the Pulse Transformer circuit board (polarity is not important) and, using
the TA potentiometer on the lower right corner of the Pulse Transformer
circuit board, set the total resistance (RTA) to the appropriate value as
indicated in
Table C or Table D in the Total Resistance Values section on
page 16 .
1 . . . . . . . . . . . . . .13 . . . . . . . . . . . . . . . . . . . . 33
2 . . . . . . . . . . . . . 14 . . . . . . . . . . . . . . . . . . . 34
XR
=
The XR connector is located on
the upper right corner of the
Pulse Transformer circuit board.
The TA potentiometer is located on the lower right
corner of the Pulse Transformer circuit board next
to the control power terminal block. Shown sealed.