Rockwell Automation 20P PowerFlex DC Drive - Frame A Pulse Transformer Circuit Board - Manual (Page 13)

PowerFlex® DC Drive - Frame A Pulse Transformer Circuit Board 13
Step 5: Configure the New
Pulse Transformer Board The Pulse Transformer circuit board must be configured to match the drive
size (armature output current and HP rating). The steps required to complete
the configuration are different based on the revision code of the board. See
either,
Pulse Transformer Board FIR1-XX Rev. “P” and Lower below, or
Pulse Transformer Board FIR1-XX Rev. “Q” and Higher on page 17 .
Pulse Transformer Board FIR1-XX Rev. “P” and Lower
Important: This step requires a multimeter that measures resistance to
thousandths of an ohm.
1. Cut and remove the appropriate sizing resistor(s) (if necessary) from the
Pulse Transformer board based on the drive size. Refer to Table A or
Table B in the Sizing Resistor Configuration section on page 14 for the
appropriate configuration.
=
Sizing resistors are located on the lower right
corner of the Pulse Transformer circuit board.