Rockwell Automation 20P PowerFlex DC Drive - Frame A Pulse Transformer Circuit Board - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame A Pulse
Transformer Circuit Board
What This Kit Includes
•
Pulse Transformer circuit board
•
Six screws with washers
•
6 gate lead cables with connectors (for non-regenerative drives only)
•
12 gate lead cables with connectors (for regenerative drives only)
•
Cables for connectors X3 (2 pin) and XP (34 pin)
•
Cables for connector X4 (for drives with a fan only)
•
Plug-in terminal block with 1k ohm resistor @ terminals 78-79
•
Isolation sheet
•
Flathead screwdriver for terminal block connections
•
Static strap
Tools That You Need
•
Phillips
®
screwdriver
•
Flathead screwdriver
•
Nut driver or wrench for hex stand-offs
•
Multimeter (capable of reading to a thousandth of an Ohm)
•
Wire Cutter
Phillips
®
is a registered trademark of Phillips Screw Company.
ATTENTION: Only qualified personnel familiar with DC
drives and associated machinery should plan or implement the
installation, start-up and subsequent maintenance of the system.
Failure to comply may result in personal injury and/or equipment
damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the
following.
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD
control procedures are not followed. If you are not familiar with
static control procedures, reference A-B publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other
applicable ESD protection handbook.