Vicor FlatPAC-EN MI EN Compliant Autoranging Switchers - Manual (Page 19)

03-000050 rev A Vicor 800-735-6200 Westcor Division 408-522-5280 Applications Engineering 800-927-9474 Pg. 19
FlatPAC-EN/EN MI Design Guide
2 VI-J00 modules only.
O UTPUT ( CONT ’ D .)
Maxi/Mini/Micro Modules
Parameter MIN. TYP. MAX. UNITS NOTES
Setpoint Accuracy* ±0.5 ±1 % of V
NOM
Load Regulation ±0.01 % of V
NOM
See module design guide for e
exact specifications.
Temperature Regulation 0.002 0.005 %/°C -20 to 100°C
Long Term Drift 0.02 %/K hours
Output Ripple and noise:
Maxi 75 mV p-p See module design guide
Mini 100 mV p-p for exact output ripple
Micro 125 mV p-p specifications.
Voltage Trim Range
Maxi/Mini/Micro Slots 10-110 % Vout Preload may be required.
Total Remote Sense Compensation 0.5 Volts Autosense. See pg 14
OVP Set Point 112 135 % of V
out
Recycle power
Current Limit 102 115 135 % of I max Auto Recovery
Overtemperature Limiting Not available
* For special, adjustable voltages and 48Vdc outputs, maximum setpoint accuracy is 2% of Vnom.
Note: See individual module datasheets for specific module specifications.
E NVIRONMENTAL
Storage Temperature -40°C to +100°C
Operating Temperature
Ambient air (see derating curves) -20°C to +70°C (MI -40°C to +70°C)
Case Temperature -20°C to +90°C (MI -40°C to +90°C)
(75° for full size VI-200 module)
Specific temperature data on all module configurations can be obtained by contacting Applications Engineering.
Altitude Derate 2.6% total output power for each 1,000 ft to a maximum
operating altitude of 15,000 ft. Non-operating storage maximum
altitude is 40K.
Humidity 0 to 95% non condensing
Product Weight 3.4 lbs. (1,5 kg)
Dimensions 1.4" H (35,6mm) x 5.0" W (127,0mm) x 9.20" L (233,7mm)
Warranty** 2 years limited warranty. See vicorpower.com for complete warranty
statement.
** Opening, repairing or modifying the unit will void the warranty. If you have any problem with the power supply, please
contact Customer Service at 1-800-735-6200. If the unit needs to be returned for inspection/analysis, an RMA number will
be issued. All units must have a RMA number prior to return.