USG C2 Paired Compasso Channels - Manual (Page 8)

Step 1 Corners are formed using notched and
scored trim for outside corners and pre-
mitered trim for inside corners.
To create an outside corner, bend notched
corner trim along the score to the desired
angle and slide a standard splice part way
in on each side.
Step 2 Slide the corner unit into place to join the
outer C
2 channels.
Step 3 To form an inside corner unit, start by snip-
ping the top and bottom flanges of an inside
corner splice at the center
Page 8 of 12
Installation
Instructions Corner Installation
pre-mitered
C
2 channel
components
splice
C 2 channel
splice
snip top and bottom
flange at center