Regency Energy E18 Small Gas Insert - Manual (Page 48)

48
Regency ® E18 Gas Fireplace Insert
INSTALLATION
LOG TRAY INSTALLATION LOG SET INSTALLATION
1. Remove the Log Burner Tray from the box. Hang the front
burner cover on the front edge of the burner tray. Place the Log
Burner Tray on the Glass Burner Tray.
2. Screw the Log Burner Tray to the Glass Burner Tray.
3. Install the Log Burner the same way as the Glass Burner (see
installation manual for instructions).
4. Fill the Log Burner with 2lbs of black glass crystals.
2. Place Log B at the front left of the Log Tray.
Read the instructions below carefully and refer to the images. If the
are broken do not use the unit until they are replaced. Broken logs
interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and
alter the unit's performance which is not covered under warranty.
Log Kit #619-935 contains the following pieces:
1. Place Log A over the two posts at the back of the log burne
Installation of Panels must be completed before
installing the log set.
* Log instructions shown with Black Enamel Panels
A
A
B
A Rear Log
B Front Left Log
C Front Right Log
D Left Side Log
E Right Side Log
946-675 2lb Fireglass
946-669 Platinum Embers
946-708 Embaglow Embers
1C Ember Lava
616-515 Log Tray Assembly
Screws x 2