Regency Energy E18 Small Gas Insert - Manual (Page 39)

Regency ® E18 Gas Fireplace Insert
39
INSTALLATION
/HJ+HLJKW
([LVWLQJ)LUHER[ 9HQW6OLGH3ODWH
2XWHU6KHOO/HJV[
)DVWHQLQJ6FUHZV
2XWHU6KHOO6FUHZV[
9HQW6OLGH3ODWH
DWWDFKHPHQWVFUHZ
'UDIWKRRG
%RWWRP
'UDIWKRRG6OLGH
&RQWURO%R[
6XUURXQG
0RXQWLQJ
%UDFNHW
/HIW
:LUH+DUQHVV
8SSHU'UDIWKRRG
%DIIOH
6XUURXQG0RXQWLQJ
%UDFNHW5LJKW
STEP #2: OUTER SHELL INSTALLATION
1. Slide outer shell back into the existing fi rebox, ensure the vent slide
plate is properly engaged with the outer shell.
Move the outer shell back until the left and right fl anges contact
the existing fi rebox.
2. Adjust the outer shell legs to the setting noted for your specifi c
installation. If these settings are not adhered to, the surround will not fi t
correctly.
3. Attach the bent slide plate to the outer shell with one sheet metal
screw as shown in Figure 10.3. Refer to the applicable existing appli-
ance for correct measurements before securing outer shell in position.
4. Ensure the unit is set at the correct height and the outer shell is square
and centered, fasten the outer shell to the existing fi rebox using self
tapping screws.
1. Ensure thermodiscs and thermodisc brackets are in
place.
2. Install the fi rebox into the outer shell by sliding the
drafthood bottom onto the drafthood slide until you are
able to install 4 screws to secure the fi rebox. Use care
to avoid damaging the wire harness.
Note: 2 of the screws along with panel brackets to be
installed on the lower inside of the fi rebox.
3. Unit is installed correctly when the fl anges that se-
cure the fi rebox to the outer shell contact. Ensure the
unit is centered within the existing fi rebox, attach the
outer shell to the existing fi rebox using 4 x sheet metal
screws.
4. Install 2 self tapping screws at the front edge corners of
the drafthood bottom to secure the drafthood.
5. Install 1 x Phillips screw to fasten drafthood. Install 2 x
Phillips screws to secure left and right side of thermo-
disc bracket.
STEP #3: FIREBOX INSTALLATION
Diagram 10.3
Diagram 10.4
ZC box existing Unit Measured from
Top of ZC box Measured from side of
ZC box
EP28 8-7/16" (215mm) 1-7/16" (37mm)
28F - 28F2 7-3/16" (183mm) 1-1/2" (39mm)
Montigo 36SR 6-3/8" (162mm) 1-9/16" (40mm)
Firesong 220N 8-3/16" (208mm) 2-1/8" (54mm)