Regency Energy E18 Small Gas Insert - Manual (Page 17)

Regency ® E18 Gas Fireplace Insert
17
INSTALLATION
REQUIRED STEPS AND PROCEDURES FOR E18 INSTALLATION
1. Locate model on existing ZC box - locate corresponding section in this manual.
2. Make necessary alteration to the ZC fi rebox as per manual.
3. Separate inner and outer fi re box (see procedure in manual).
4. Remove fl ue adaptor for outer fi rebox.
5. Make necessary adjustment to fl ue adapter mounting plate as per manual.
6. Cut fl ex to required length and secure to top plate using 3 screws and washers.
7. Secure top plate fl ue adapter to ZC box.
8. Secure fl ue adapter to fl ex using 3 screws/washers.
9. Slide outer fi rebox into place, be sure fl ue adapter mounting screw doesn't hold unit up on installation.
10. Adjust left and right side lgs on outer shell (depends on ZC box it is being intalled in) - See details in manual.
11. Measure and align outer fi rebox as per manual, secure each corner using self tapping screws.
12. Install inner fi rebox into outer fi rebox, ensure draft hood bottom fi ts on top of draft hood slides, left side, right side and rear.
13. Secure inner fi rebox - 2 screws on top left and right side - using existing holes.
14. Secure inner fi rebox on bottom inside - 2 screws on each side. Be sure to re install panel brackets, and line up with existing holes.
15. Reinstall burner.
16. Make gas connection - check for leaks.
17. Install enamel panels.
18. Install Faceplate
19. Install Glass Crystals on burner.
20. Light pilot.
21. Install glass door.
22. Install thermostat.
• Nibbler
• Oscillating tool / metal blades
• Tin
snips
• Uni Bit/Step Drill
• Black high temp paint
• Drill/ ¼” bit – Phillips bit
• Measuring
tape
• Level
• Sharpie
• Shop
vacuum
TOOLS REQUIRED (SUGGESTED)
Nibbler
Oscillating tool
Optional:
• Plasma cutter
• Fibre drop sheet
• Fire
extinguisher