Regency Energy E18 Small Gas Insert - Manual (Page 20)

20
Regency ® E18 Gas Fireplace Insert
INSTALLATION
E18 INSTALLATION SPECIFICATIONS
See Installation of E18 into Existing Units for General Installation Guidance - for vent connection confi guration.
This install of the E18 uses Vent Connection Type A .
The length of 4" Flex needed is 4 -1/8" semi-expanded.
Secure fl ue adapter top plate to under side of existing fi rebox using 4 self tapping screws.
The height of the unit installed is shown below.
PP
PP
PP
$
(3)LUHER[
/HJ
Right side shown
PP
PP
%
(3)LUHER[ (,QVHUW
'(7$,/%
6&$/(
$GDSWRU3ODWH
IDVWHQHUVHWWLQJ
)OH[$GDSWRU/HQJWK
&ROODU3ODWH6HWWLQJ9HQWSRVLWLRQ
1. Loosen 2 x Phillips screws on both right and left legs.
2. See above diagram below for required leg setting.
3 Install with supplied Phillips screws to pre-punched holes and tighten previous screws that were loosened in Step 1.
4. Keep left side leg loose until outer fi rebox is in position in ZC box - to allow adjustment of gas line.
EP28-4 / EP28-5 INSTALLATION SPECIFICATIONS
Set to this
hole
Set to this
hole
Secure top plate to fi rebox w/4 screws.
Secure vent slide plate to fl ex pipe with 4
screws