BT Diverse 1015 - Manual (Page 51)

To set/clear the display of the base unit
number on a handset
The factory setting is to display the number.
This is useful if your handset is connected to
more than one base unit.
• Press the STO button.
• Press the 3 button then the 6 button.
The current setting is displayed.
• Press the 1 button to display the base unit
number.
or
• Press the 0 button if you do not want to
display the base unit number.
• Press the STO button to confirm.
48
Operating with additional
base unit
STO
To set your handset for automatic base
selection
If you are moving around, and likely to lose
contact with your base unit, your handset can
be made to automatically switch to the first
available base unit. If this is set and you are in
the area where the signals of two base units
are overlapping, your handset will select the
strongest signal.
The handset must be switched ON
• Press the STO button.
• Press the INT button. Display shows the
numbers of the base stations at which the
handset is registered.
• Press the 0 button to set automatic selection.
• Press the STO button to confirm. The
handset will now select the base unit offering
the strongest signal. Display will show the
base unit selected (unless de-activated – see
previous paragragh to set/clear the display
of the base unit number on a handset).
STO INT
7 PQRS 6 MNO
0