Skyjacker 9003 - Manual (Page 2)

Installation:
1. Park the vehicle on a level concrete or asphalt surface with the front tires / wheels pointing
straight forward.
2. Set the emergency brake & block the rear tires / wheels.
3. Remove the OEM steering stabilizer from the vehicle.
4. Install the supplied boot over the new Skyjacker steering stabilizer.
5. Install one supplied poly bushing
& steel sleeve at each end of
the new Skyjacker steering
stabilizer & install using the
OEM hardware. (See Photo # 1)
Note: Be sure to install so the
cylinder body is mounted to the
axle side as shown in Photo # 1.
If mounted the opposite way,
damage can occur to the new
steering stabilizer.
6. After installation be sure to cycle the steering & check for adequate clearance. In most cases the
OEM steering stabilizer bracket on the tie rod assembly will need to be rolled down slightly to
allow for adequate clearance.
Final Notes:
• After the installation is complete, double check that all nuts & bolts are tight. Refer to the following
chart for the proper torque specifications. (Do not retighten the nuts & bolts where thread lock
compound was used.)
• Cycle the steering of the vehicle left to right & check all parts for adequate clearance.
• After the first 100 miles, check all of the hardware for the proper torque & periodically thereafter.
I-7003 Pg 2
Photo # 1