Skyjacker 7119 User Manual
Kit contents, Seat belts save lives. please wear your seat belt, Jeep

KIT CONTENTS:
1 - 7900WS Stabilizer
2 - 83161 Mounting Brackets
4 - Stem Bushings
2 - 142120 Washer/Nut Packs
2 -
5
⁄
16
" x 1" x 2
1
⁄
4
" U-Bolts, Nuts, & Washers
2 -
5
⁄
16
" x 1
1
⁄
4
" x 2
1
⁄
4
U-Bolts, Nuts, & Washers
1. Place wheels in straight forward position.
2. Place boot onto stabilizer, but
do not secure boot with boot tie at this time.
3. Install both brackets onto each end of stabilizer using bushing & washer packs provided.
4. Pull the stabilizer rod out EXACTLY half-way out. Stabilizer must be kept out exactly half-way
during installation.
5. Mount stabilizer in place (Refer to Photo). Install U-bolts (
5
⁄
16
" x 1
1
⁄
4
" x 2
1
⁄
4
" around track bar &
5
⁄
16
" x
1" x 2
1
⁄
4
" around tie rod assembly), but
do not tighten yet.
NOTE: Be sure the passenger bracket is located directly below the tie rod clamp. (See
Arrow Below) After brackets are in position, tighten the U-bolts.
6. Turn wheels fully to the left & right to make sure stabilizer is adjusted properly. (Refer to Step # 4)
7. Place boot tie around boot & secure.
SEAT BELTS SAVE LIVES. PLEASE WEAR YOUR SEAT BELT
Pg 1
I-7119 REV1 3-11
JEEP
®
SINGLE STABILIZER KIT
INSTALLATION INSTRUCTIONS
Part # 7119
#7009
#7119
www.skyjacker.com