Skyjacker 9055 - Manual (Page 2)

Installation:
1. Park the vehicle on a level concrete or asphalt surface with the front tires / wheels pointing
straight forward.
2. Set the emergency brake & block the rear tires / wheels.
3. Remove the OEM steering stabilizer.
4. Install the supplied tapered stud into the OEM tie rod.
5. Install the supplied bushing & sleeve into the body end eye of the new Skyjacker steering
stabilizer & attach to the OEM axle bracket using the OEM hardware.
6. Install the supplied boot over the shaft end of the new Skyjacker steering stabilizer & install the
supplied bushing into the shaft end eye of the new steering
stabilizer.
7. Mount the shaft end of the new Skyjacker steering stabilizer to the new stud on the OEM tie rod.
Final Notes:
• After the installation is complete, double check that all nuts & bolts are tight. Refer to the following
chart for the proper torque specifications. (Do not retighten the nuts & bolts where thread lock
compound was used.)
• Cycle the steering of the vehicle left to right & check all parts for adequate clearance.
• After the first 100 miles, check all of the hardware for the proper torque & periodically thereafter.
I-7055 Pg 2
Photo # 1