Skyjacker 9100 - Manual (Page 2)

Shock Stud
Stem Bushings
Retaining Washer
Retaining Washer
Bracket
Retaining Nut
installation:
1. Park the vehicle on a level concrete or asphalt surface with the front tires / wheels pointing
straight forward.
2. Set the emergency brake & block the rear tires / wheels.
3. Place the new Skyjacker main bracket “A” against the front of the axle on the driver’s side &
install the supplied large u-bolt around the axle to the new main bracket. (See Photo # 1)
4. Install the body end of the new Skyjacker steering stabilizer to the new main bracket using the
supplied bushings & washer pack. (See Photo #1 & # 2)
5. Install the new Skyjacker tie rod bracket "B" using the supplied small u-bolts around the tie rod &
install shaft end of the new steering stabilizer using the supplied bushings & washer pack. (See
Photo # 1 & # 2)
6. Slide the new Skyjacker tie rod bracket down the tie rod until the steering stabilizer shaft is
exactly half way out (4.08”). Rotate the new tie rod bracket as needed for the best fit & clearance
of the differential & tighten the new tie rod bracket. (See Photo # 1)
I-7100 Pg 2
Photo # 2
Bracket “B” Bracket “A”
Photo # 1