Skyjacker 9160 - Manual (Page 2)

I-7160 Pg 2
Bracket “A”
Bracket “B”
Bracket “A”
Bracket “B”
important Note:
Skyjacker steering stabilizer Part # 7160 is designed to fit several makes of vehicles covering
several years. Configuration of the front end of your vehicle will determine where you mount the
steering stabilizer. Differential cases are located either on the left or right side depending on the
vehicle. This steering stabilizer can be installed on either side.
installation:
1. Park the vehicle on a level concrete or asphalt surface with the front tires / wheels pointing
straight forward.
2. Set the emergency brake & block the rear tires / wheels.
3. Install the new Skyjacker bracket “A” onto the axle housing tube using the supplied u-bolts,
washers, & nuts. (See Photo # 1) Note: Do not tighten at this time.
4. Install the body end of the new Skyjacker steering stabilizer onto the new bracket “A” using the
supplied bushings & washers. (See Photo # 2)
5. Install the shaft end of the new Skyjacker steering stabilizer to bracket “B” using the supplied
bushings & washers. (See Photo # 2)
6. Extend the new Skyjacker steering stabilizer shaft out 4”(exactly half way) & mount onto the OEM
tie rod using the supplied u-bolts, washers, & nuts. Rotate the new brackets “A” & “B” as needed
to obtain the best position & tighten all hardware.
Photo # 1