Skyjacker FJ20MS - Manual (Page 4)

11. Re-Attach outer tie rod end. Torque retaining nut to factory specs.
12. Tighten upper 7/16" nuts. Torque to 50 Ft. Lbs.
13. After both sides are completed re-attach sway bar and factory end
links and ABS lines. (See Photo #8).
14. Install tires and wheels. Lower vehicle to the ground.
Rear Installation:
15. Raise the rear of the vehicle and properly support frame rails
using jack stands.
16. Remove tires and wheels. (See Photo #9). Remove rear shocks.
17. It will be necessary to disconnect the brakeline brackets and sway
bar end link from the axle to allow for installation of the new rear
spacer.Disconnect the track bar from the frame. (See Photo #10).
18. Install new rear spacer on top of factory bump stop pad and
factory coil spring. (See Photo #11)
19. Install coil spring assembly.
20. Re-Attach track bar, brakelines and sway bar end links.
21. Install new rear shocks. Be sure to install the aluminum spacer
supplied with the shock between the oe mount and the shock.
This will allow for proper clearance between shock body and axle.
(See Arrow in Photo #12)
22. Install tires/wheel and lower vehicle to the ground.
FINAL NOTES:
* After installation is complete, double check that all nuts and bolts are
tight. Do Not tighten nuts/bolts where thread locking compound was
applied.
* Check to ensure there is adequate clearance between All rotating,
mobile and fixed members. Check clearance between inner side
wall of tires.
* Ensure there is adequate clearance between exhaust and brake
lines, fuel lines, fuel tank, floor board, and wiring harnesses. Check
steering gear for interference and proper working order. Inspect
brake lines for damage and adequate clearance. Test brake system.
* With the vehicle on the floor, cycle steering lock to lock and inspect
steering, suspension, drive line and brake line systems for proper
operation, tightness and adequate clearance.
* Front end realignment is necessary so have a qualified alignment
center realign front end to factory specifications.
I-FJ20MS Pg 4
Photo #9
Photo #10
Photo #11 Photo #12
Photo #8