Skyjacker TC530 User Manual
Instructions

IMPORTANT NOTES
-Skyjacker strongly advises taking extreme caution when working with loaded coil springs to
prevent accident or harm.
-Trucks w/o manual locking hubs, height must not be adjusted over 2" above factory height.
-Both coil over assemblies should be adjusted to the same length after installation. It is VERY
IMPORTANT that after installation the coil does not have any slack between the mounting
cups. At no time during axle travel should the coil lose contact with the mounting points.
-When final adjustments are made the setscrew MUST be tightened. At no time should the
coil over assembly be ran without the set screw being tight.
Part #
Description
Qty
TOY20153-S
2.5-3" COIL-2" COIL
2
SKY201-S
SKYJACKER 2" SHOCK
2
T5USM-B
UPPER SHOCK MOUNT
2
T5SBB-S
SWAY BAR LOWERING BLOCK
2
916X212X7U
9/16 X 2 1/2 X 7 U-BOLT SQUARE
4
716X1FTB
7/16 X 1 BOLT,FINE THD GRD8
6
12X212FTB
1/2 X 2 1/2 FINE THRD BOLT
2
716FTN
7/16-20 FINE N/I LOCK NUT
6
12FTN
1/2-20 FINE N/I LOCK NUT
2
716SAEW
7/16 SAE WASHER
12
12SAEW
1/2 SAE WASHER
4
10X20MMB
10 X 20 METRIC BOLT/10.9
4
38SAEW
3/8 SAE WASHER
4
916FTN
9/16-18 NYLON INSERT LOCKNUT
8
916XTFW
EXTRA THICK 9/16” WASHER
2
Instructions:
Front:
1. With vehicle on flat level ground, measure from center of front spindle to
the top of fender opening. Record measurement for later use.
2. Raise the front of vehicle in the center of the front cross member using
floor jack.
3. Support the vehicle on the frame cross member so that the front tire/wheels
are off the ground. Remove front wheels.
4. Remove the ABS line from the upper A-Arms using 10mm wrench. (See
Photo #1) Disconnect ABS/Brake line from steering knuckle.
5. Remove sway bar end links using 17mm. (See Arrow in Photo #2)
6. Remove cotter pin from outer tie rod. Disconnect tie rod using 12 mm sock-
et. (See Photo #3)
7. Remove cotter pin from upper ball joint, remove using 19mm socket. (See
Photo #4)
8. Locate lower shock mounting bolt. Remove lower shock mounting bolt
using 19mm socket. (See Photo #5)
9. Disconnect upper shock assembly from frame using 14mm wrench. (See
Photo #6)
10. Disconnect front sway bar from the frame.
Photo #1
Photo #2
Pg 1
2005-2006
Toyota Tacoma 2-2.5" - 3”
Platinum Series Coil Over
Installation Guide
Part# TC530K, TC530KS
I-TC530 01-26-06
Photo #3