Skyjacker TT20MS - Manual (Page 4)

11. Re-Attach outer tie rod end. Torque retaining nut to factory specs.
12. Tighten upper 7/16" nuts. Torque to 50 Ft. Lbs.
13. After both sides are completed re-attach sway bar and factory end
links and ABS lines. (See Photo #8).
14. Install tires and wheels. Lower vehicle to the ground.
FINAL NOTES:
* After installation is complete, double check that all nuts and bolts are
tight. Do Not tighten nuts/bolts where thread locking compound was
applied.
* Check to ensure there is adequate clearance between All rotating,
mobile and fixed members. Check clearance between inner side
wall of tires.
* Ensure there is adequate clearance between exhaust and brake
lines, fuel lines, fuel tank, floor board, and wiring harnesses. Check
steering gear for interference and proper working order. Inspect
brake lines for damage and adequate clearance. Test brake system.
* With the vehicle on the floor, cycle steering lock to lock and inspect
steering, suspension, drive line and brake line systems for proper
operation, tightness and adequate clearance.
* Front end realignment is necessary so have a qualified alignment
center realign front end to factory specifications.
I-TT20MS Pg 4
Photo #8