Skyjacker HB-916 User Manual
Skyjacker For the car
2007- 2014 Toyota Tundra
1"- 3” Performance Strut
Installation Instructions
www.skyjacker.com
I-TU730ST REV3 6-14
Pg 1
RequIRed Tool lIST:
• Safety Glasses
• Metric / Standard Wrenches & Sockets
• Floor Jack / Jack Stands
• Measuring Tape
• Strut Spring Compressor
• Torque Wrench
Before beginning the installation, thoroughly & completely read these instructions & the enclosed
driver’s WARNING NOTICE. Affix the WARNING decal in the passenger compartment in clear view
of all occupants. Please refer to the Parts List to insure that all parts & hardware are received prior
to the disassembly of the vehicle. If any parts are found to be missing, contact SKYJACKER®
Customer Service at 318-388-0816 to obtain the needed items. If you have any questions or
reservations about installing this product, contact SKYJACKER® Technical Assistance at 318-388-
0816.
Park the vehicle on a level concrete or asphalt surface. Many times a vehicle is not level (side-to-
side) from the factory & is usually not noticed until a lift kit has been installed, which makes the
difference more visible. Using a measuring tape, measure the front & rear (both sides) from the
ground up to the center of the fender opening above the axle. Record this information below for
future reference.
Driver Side Front:
Passenger Side Front:
Driver Side Rear:
Passenger Side Rear:
Important Notes:
•
If larger tires (10% more than the OEM diameter) are installed, speedometer recalibration will be
necessary. Contact your local Toyota dealer or an authorized dealer for details.
• After installation, a qualified alignment facility is required to align the vehicle to the OEM
specifications.