PIAA 2000 Series - Manual (Page 6)

-6-
PKI-0004
The numbers shown in the figure below indicate the sequence the parts should be installed.
Remove the (-) termi-
nal from the battery.
Remove the (+) termi-
nal from the battery
Bring the relay connector into the
interior of the vehicle and connect
to the switch s connector.
Double-sided tape (Item 5)
Place in area that is easily acces-
sible from driver s seat.
Take the (+) cord (white) and using the
one-touch connector (Item 6), tie it
together to the vehicle s (+) cord.
Connect the lamp harness to the
connector.
First ground the terminal then take
the (-) cord (black) and connect it
to the (-) terminal.
Take the (+) terminal
cord (white) and attach
it to the (+) terminal and
connect to the battery
Attach the (-) terminal
to the battery
After lamp has been installed, verify the relay
harness does not make contact with the
engine s moving parts or sections that emit
extreme heat. Use the wire tie included (Item 7)
and secure to harnesses inside engine
compartment.
【2】Relay Harness Installation Sequence
Harness
Wire tie
※ Use a pair of pliers to verify the
one-touch connector is secure.
Switch
Relay
(+) cord (white)
Battery
PL5FB (line relay)
Secure relay bolt so
that connector is
facing downward.
Facing
down
Cord
One-touch connector
(+) cord (white) (-) cord (Black)