PIAA 2000 Series - Manual (Page 10)

-10-
PKI-0004
Connect the bulb s lead wire to the harness for the (+) terminal. Make sure the sleeve completely covers the terminal.
Sleeve
(-) Harness (black)
Lead line
Bulb
(+) Harness
5
4
Clasp
Bulb
Clasp
5
①
②
● Improper connection may lead to a short or can be a potential fire hazard.
● Make sure the sleeve covers the terminal section completely.
Cross-section
Combine the main unit of the lens and lamp housing. Use the 4 screws to firmly fix the unit into place.
Gently pull the lamp harness and pull out excess slack from inside the lamp.
Re-adjust the angle of the lamps beam
Screw
Lamp body
Lens Unit
6
7
8
Figure seen from front
Sleeve
As shown in the figure, place the sleeve
over the lamp housing.
● After reassembling the unit, make sure the harness is not inadvertently caught in the lamp
assembly. Such conditions may cause a short. It may also cause water to seep into the unit.