MTS 318 Load Unit - Manual (Page 75)

Routine Maintenance Overview Checklist
318 Load Unit Maintenance 75
Actuator Area is Dry MTS MTS MTS MTS
Actuator Platen Area is Clean MTS MTS MTS MTS
Piston Rod Wear is Acceptable MTS MTS MTS MTS
Bionix Lubricate Axial/Torsional Spline
(75-100 hrs) MTS MTS MTS MTS
Hydraulic Service Manifold
Cursory Check of Hydraulic Service
Manifold MTS MTS MTS MTS
Monitor Filter Indicators MTS MTS MTS MTS
Manifold Hose Connections are Tight MTS MTS MTS MTS
Accumulator Connections are Dry MTS MTS MTS MTS
Accumulator Connections are Tight MTS MTS MTS MTS
Accumulator Caps/Guards are Present MTS MTS MTS MTS
Oil on the Gas Side of the Piston MTS MTS MTS MTS
Check and Adjust Pressure in
Accumulator MTS MTS MTS MTS
Change Filters MTS
Low Pressure Adjustment (Model 294) MTS
Hoses/Cables
Cursory Check of Hoses/Cables/
Connectors MTS MTS MTS MTS
Absence of Hose Abrasions, Blisters,
Vulcanizing MTS MTS MTS MTS
Cable Condition and Routing is
Acceptable MTS MTS MTS MTS
Check Transducer Connections MTS MTS MTS MTS
Hose Connections and Crimps are Dry MTS MTS MTS MTS
Complete System
Overall System Condition is Acceptable to
Use MTS MTS MTS MTS
Turning Parameters are Appropriate/
System Stable MTS MTS MTS MTS
E-Stop is Working if Applicable MTS MTS MTS MTS
Recommended service to be performed at each running time interval noted
C ALENDAR T IME USING 8 HOUR R UNNING T IME RATE
PER DAY
D AILY W EEKLY B IWEEKLY A NNUALLY
R UNNING T IME -H OURS 8 40 80 500 1000 1,500 2,000