MK Diamond MK-1600 Series - Manual (Page 20)

20
Dry Cutting
(K)
When the cut is complete, raise
the Blade completely out of the
cut by turning Depth Control
Wheel counter-clockwise.
MK-1600 OPERATION
(L)
Close Cooling Supply Valve.
(M)
Move the Throttle Lever to
lower blade speed.
(N)
Place Engine Master Switch in
the OFF position. Place Fuel
Valve in the OFF position.
Refer to Engine Manual.
1. Ensure the blade you are using is clearly marked for dry cutting.
2. Check the condition of the air filter at least every four hours of operation.
Refer to Engine Manual for details.
Perform the cut using only enough pressure to follow the original marked line. The saw has a
natural tendency to pull towards the side on which the blade is mounted. To assure straight line
cutting, apply pressure to the appropriate handle. If excessive pressure is required reduce the
forward speed of the saw. Driving the saw too fast while cutting may cause the front wheels
to lift causing the blade to cut at uneven depths. Do not attempt to steer the saw. Sudden and
severe corrections can cause the blade to be damaged or broken.
Airflow helps to cool the blade during dry cutting. Cutting too deep with one pass, or exerting exces-
sive forward or side pressure can be dangerous and cause damage. Step cut in increments of 2
inches or less, for best results. Thinner blades are especially advantageous when cutting dry.
NOTE:
NOTE:
(J)
Slowly lower the Blade until the
desired level is reached and
begin the cut.