MK Diamond MK-1600 Series - Manual (Page 14)

14
MK-1600 ASSEMBLY
Filling Oil Reservoir
(A)
Verify the Oil Drain Cap is
installed onto the Oil Drain Line
and is tight. Refer to Engine
Manual for details.
(C)
Install one Washer onto each bolt.
Install bolt through the Handlebar
and into the holes and tighten.
Follow the assembly instructions to prepare your saw for operation.
(A)
Locate the threaded holes on
both sides of the handlebar.
(B)
Align the handlebar with the
holes on both sides of the
frame at the desired height.
Handlebar Assembly
The engine is shipped with no oil in the crankcase. Refer to the engine manual for de-
tails on the type and amount of oil required.
To fill the crankcase with oil, place the engine level. In order for this to be accomplished
the blade must not be installed, and the depth adjustment must be down (until the en-
gine is level).
NOTE: