MK Diamond MK-1600 Series - Manual (Page 18)

18
MK-1600 OPERATION
Front Pointer Alignment
Adjusting Depth of Cut Gauge
The Front Pointer is set in line at the factory. However, the pointer should be checked for proper
alignment with the blade after every use.
(A)
Using a straight edge, carefully
mark a line 12 feet long on a
smooth level concrete surface.
Place Saw parallel to line; lower
Blade and center it over the line.
(B)
With the Blade centered over the
line and the Saw Frame paral-
lel to the line, lower the front
Pointer assembly and position
the pointer over the line.
(C)
Adjust the Pointer in or out if the
orange wheel is off the line by loos-
ening the thumbscrew on the end of
pointer. Align orange wheel with line
and tighten thumbscrew.
(B)
Turn Crank Wheel until Blade
touches the ground.
(A)
Loosen Depth Lock Knob.
(E)
Tighten Depth Lock Knob.
(D)
Tighten Depth Indicator Knob.
(C)
Loosen Depth Indicator Knob and
slide the Depth Control Clamp until
the Depth of Cut Indicator reads
zero.