MK Diamond MK-5005S - Manual (Page 34)

34
(A)
Verify the motor ON/OFF
switch is in the ON position
(D)
Verify the circuit breaker is at
least 30 amps - if not, move to
30-amp circuit
(B)
Verify the MK-5005S is con-
nected to the power source
(E)
Verify circuit breaker is not
tripped, if tripped, reset once
(C)
Allow motor to cool and
depress the motor Overload
Reset Switch
(F)
Check power source voltage
is 230V - if not 230V, move to
another circuit
Blade Stops Turning
MK-5005S TRoUBlESHooTING
Blade will Not cut Properly
(A)
Check for smoothness
or “glazing”
(B)
Check for proper rotation
(C)
Ensure Blade Core is not bent.
Verify blade is correct for
material being cut